Your cart is empty
Welcome,  Log In   |   First time visitor? Create a  New Account

Finned Walnut Case for QTC+ and Elite Clocks

Price: £44.95


Add to Cart:

The case is supplied fully machined, including tube cutouts and pilot holes for mounting the PCB. The base cover is laser-cut from clear perspex acrylic sheet, allowing you and friends to peek inside the clock at the PCB.



The case needs to be finished by sandpaper or a sanding machine. Use 120, then 400 grade papers and finally 000 grade wire wool to give a very fine surface. The wood may be finished with your choice of oil, wax or lacquer.


Pictured here with a Tung Oil finish, with our QTC+ IN-14 kit (not included) - available here



  • Pack Contents:
    Machined case in Black Walnut for 'Nixie QTC, QTC+ and Elite Clock kits
    Laser - cut base cover in clear perspex
    Hardware pack - all screws and fixings for PCB and cover
    Applicability:
    Nixie QTC, QTC+, Elite - all PCB dates, all tube types


    The bare machined case, which you will enjoy sanding and finishing to your own liking - oiled, waxed or gloss. 


    Pictured here with our top end kit - the Elite with NL840 tubes. Kit available here


    Here you can see the engraved rear panel, with holes for the sync, alarm and DST LEDs as well as the holes for the power supply and optional GPS or WiFi time receiver modules 

  • Model:
    [QTCWALNUT]
  • Shipping Weight: 0.25kgs
  • 65 Units in Stock

-->